展覽主題
數位轉型
綠色轉型
HYDROKOMP GmbH
產品描述 :
Swing clamp cylinders release the clamping point on the workpiece. With this, it is easy to change the workpiece. This hydraulic swing clamp cylinder operates as single-acting or double-acting traction cylinder, whereas part of the stroke is used to rotate the piston. The model with 0° swing angle operates only vertical as traction cylinder.
To guarantee a long lifetime the cylinders have an integrated metal wiper as standard. For oil supply, the cylinders are equipped with threaded port and manifold port with O-ring for drilled channels. You can select between right or left turning models with various standardized swing angles. The integrated overload protection protects the swing mechanism from damage due blockage of the rotation or improper assembly of the clamping arm.
For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line. Counter-hold the clamping arm when tightening or loosening the counter nut in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide. Variations with 0°, 30°, 45°, 60° and 90° swing angles are available. The permitted operating pressure is depending from the clamping arm length.
銣佳科技有限公司
產品描述 :
氣動電熱剪是一種利用刀片的電阻，通過大電流來實現雙刀刃發熱的電熱刀，其預熱時間短，只要幾秒鐘刀片就能夠達到紅熱的狀態，產品採用的是雙軸氣缸，壓力範圍0.15～1Mpa，刀刃為雙刃採用工具鋼特殊熱處理，上下刀座各一加熱棒（ψ8mmx35mm)，其加熱功率150W、溫度範圍為60～350℃，藉由雙軸氣汽缸前進搭配刀刃溫度控制器的設定達到穩定的剪切效果，因此其效率甚高（直接用刀片發熱，損耗小），剪切速度快，可以根據不同的塑膠材料以及場合選擇不同的溫度，搭載在機械手臂或自動化生產線上，其適用範圍廣，可用於切割汽車車燈、壓克力、光學鏡頭、PC塑料等。而氣動電熱剪主要作動來源於氣壓，由於氣壓所產生的壓力遠遠大於人的手產生的壓力，所以能夠在剪切物品的時候，變得非常的容易。
HYDROKOMP GmbH
產品描述 :
Coupling elements of HYDROKOMP are made of stainless materials. This enables the elements to be used for all fluids and gases that are not aggressive. Special designs eg. for water steam or other media are available on request. HYDROKOMP offers coupling elements for two different operating modes depressurized coupling or pressurized coupling. The elements for depressurized coupling can be coupled pressurized up to 25 bar, if the specified volume flow is not be exceeded. When using higher operating pressure there ockures a risk of demaging the soft seal in the check valve as the result of high flow velocities of the fluid. This means for coupling of air up to 10 bar there should be always used the coupling elements for depressurized coupling. This also applies when the coupling process is initiated pressurized. The elements which can be coupled pressurized may be coupled up to the maximum specified operating pressure on one side and / or on both sides.
